Water Heaters
Muller Heating proudly installs Bradford White through-the-wall water heaters including chimney vent and electric. Jim installs units in new homes, replacement units and can add them to your existing home.  A 1-year labor warranty is included with each unit we sell.

The TTW1 is the first American-made through-the-wall water heater approved for use with both two and three inch PVC. Bradford White has improved again with the redesigned TTW2. This water heater has an electronic ignition system which can be vented wth both three and four inch PVC either horizontally or vertically. When it comes to through-the-wall water heaters, the TTW1 and TTW2 are the best in the business.
TTW1® RESIDENTIAL THROUGH-THE-WALL GAS
  • 1" Non-CFC foam insulation.
  • Intermittent Pilot Ignition System - no standing pilot.
  • Can be vented both horizontally and vertically.
  • May be installed up to 30' from outside wall with 2" PVC vent pipe and 3 elbows.
  • May be installed up to 90' from outside wall with 3" PVC vent pipe and 3 elbows.
  • Agency approved for use with schedule 40 ABS, schedule 40 PVC and schedule 40 CPVC.
  • Power vented for positive exhaust.
  • Vitraglas® lining.
  • Protective magnesium anode rod.
  • Factory installed dielectric waterway fittings.
  • Factory installed Hydrojet® Total Performance System.
  • Smart Valve control.
  • T&P relief valve opening on side of tank.
  • Slider Combustion Chamber Door.
  • Brass Drain Valve.
TTW2® RESIDENTIAL THROUGH-THE-WALL GAS
  • Side connections for space heating.
  • Can be vented both horizontally and vertically.
  • May be installed up to 60' from outside wall, with 4" PVC vent pipe and 3 elbows.
  • May be installed up to 30' from outside wall, with 3" PVC vent pipe and 3 elbows.
  • Agency approved for use with schedule 40 ABS, schedule 40 PVC and schedule 40 CPVC.
  • Power vented for positive exhaust.
  • Vitraglas® lining.
  • Protective magnesium anode rod.
  • Factory installed Hydrojet® Total Performance System.
  • Factory installed dielectric waterway fittings.
  • 2" Non-CFC foam insulation.
  • Smart Valve control.
  • T&P relief valve included.
  • Slider Combustion Chamber Door.
  • Brass Drain Valve.
High Efficiency, High Deliverability, Highly Effective Self-Cleaning System From Bradford White.

A clean tank is just the beginning. Bradford White's new Hydrojet® Total Performance System gives the plumbing trade a strong technological advantage. It applies the laws of physics and augments the power of flowing water to create a new level of top performance. And, it's standard equipment on all Bradford White top connect residential water heaters.*

 

The Hydro-dynamic achievement of turbulent action.

The Hydrojet® delivery tube, with a series of concentric "jet ports", creates an incredible amount of turbulent action inside the tank. Water flowing into the tank encounters a series of up to 30 flow altering "jet ports". Set at precise space intervals, these ports redirect the flow to create the dynamic mixing action. Unlike a conventional dip tube where water exits with a weak diffusing action, water exiting the Hydrojet® system is in complete turbulence. This new design is exceptionally efficient, measured to be three to five times better than an ordinary dip tube.

The bonus is a surprising increase in deliverability.

Smooth and efficient operation during continual use and in the first hour provide increased volumes of hot water no matter what the capacity of the tank. For instance, the first hour delivery for our High Recovery, Energy Saver, 40 gallon residential gas water heater was 66.6 gallons. But now, equipped with the Hydrojet® system, that same unit delivers 73.3 gallons - a 10% increase! That translates into more hot water for the money. Not simply a device to boost performance, the Hydrojet® system lengthens the operating life of a water heater. A common cause of premature tank failure and reduced energy efficiency in all water heaters is sediment build-up. The detrimental effects of this universal problem are interference in heat transfer, lower tank capacity, corrosion, early parts failure and an annoying rumbling noise. The result of all this is a water heater that must work much harder and consume much more energy. Take sediment for a ride. When the Hydrojet® Total Performance System goes to work, sediment has no place to hide. The turbulent action puts dissolved solids such as lime and other minerals into suspension when water is delivered into the tank. Whenever water is drawn, particles are prevented from settling to the bottom of the tank or building up on interior surfaces. The Hydrojet® system cleans the tank of harmful deposits every time there's a call for hot water.
*Not available on utility, tabletop or side connect models.

Visit Bradford White's website and learn more about each water heater model.

[Click here for details] [Click here for details]